One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
Cable stock in standard gauges means most replacements happen in a single visit.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Both cables typically get replaced together to avoid a near-term repeat call.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Templeton to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Templeton, CA